-= Gametoast.com =-

On entering a map where I had used some Naboo buildings and walls I noticed that they were floating - enough to roll a nade under them anyhows.

So asking what did I do wrong that theyre not snapping to the terrain flush??

The terrain is completely level btw no hills raises etc.

i came across that problem so i raised the groud around the edge of the object

select the model hold the button C and use middle mouse button............................................................................................................................................................................................................................................................................................................................................................................................................

...and move the mouse down.

Thanks guys now works great also after your advice I had a look what was going on.

I think in height in the object editor if you set it to 0 and lock it then buildings floating shouldnt be a problem However Im just testing this out so could be weird effects if youre putting something on a hill.