Floating Buildings and Walls

Emraz · Post by **Emraz** » Sun Mar 12, 2006 1:45 pm

On entering a map where I had used some Naboo buildings and walls I noticed that they were floating - enough to roll a nade under them anyhows.

So asking what did I do wrong that theyre not snapping to the terrain flush??

The terrain is completely level btw no hills raises etc.

jkempster · Post by **jkempster** » Sun Mar 12, 2006 2:33 pm

i came across that problem so i raised the groud around the edge of the object

Jawa_Killer · Post by **Jawa_Killer** » Sun Mar 12, 2006 2:52 pm

select the model hold the button C and use middle mouse button............................................................................................................................................................................................................................................................................................................................................................................................................

Post by **[RDH]Zerted** » Sun Mar 12, 2006 5:57 pm

...and move the mouse down.

Emraz · Post by **Emraz** » Mon Mar 13, 2006 9:41 am

Thanks guys now works great also after your advice I had a look what was going on.

I think in height in the object editor if you set it to 0 and lock it then buildings floating shouldnt be a problem However Im just testing this out so could be weird effects if youre putting something on a hill.